1169986 9

New product

Lifting table with dumping platform H 15-11

Add to wishlist

Capacity (kg)1500
Platform length (mm)1350
Platform width (mm)1100
Height (mm)220
Effektive stroke (mm)700
Engine power (kW)1,5
Lift time (s)25
Aggregate set-upexternal

Lifting table with dumping platform H 15-11

Application:

  • Robust design to withstand large loads
  • No deformation on the platform caused by applied forces
  • Plain bearing for long service life
  • Use of high-quality plunger cylinders
  • Solid floating bearing rollers

Technical specifications:

Payload: 1500 kg
Lifting range: 220 mm - 920 mm measured without tilting platform or 380 mm - 1080 mm incl. tilting platform
Effektive stroke: 700 mm
Lifting time: approx. 25 sec
Lowering time: approx. 25 sec
Design height: 220 mm without tilting platform or 380 mm incl. tilting platform
Platform
- dimensions: 1350 x 1100 mm
- material: 6 mm  smooth sheet metal

Hydraulic unit:

  • located outside Ex-area, (on 30 m fixed piping, loosely laid)
  • red / black lacquered
  • on a leak oil pan
  • max. duty cycle 10%

Motor:

  • 1,5 kW IE1
  • Valve: 24 VDC

Hydraulic cylinders:

  • plunger cylinder, red lacquered
  • piston rod hard chromium plated
  • operating voltage: 400 V 3/N/PE 50 Hz
  • control voltage: 24 VDC

Control:

  • EX- push button UP/DOWN EMERGENCY (dead man)
  • on 5 m cable with magnetic adhesion
  • Adjustable lifting and lowering limit switches
  • IP 54 for inside area
  • EX - lift limit switch on C-rail infinitely adjustable
  • EX - lowering lift limit switch on C-rail infinitely adjustable
  • main switch or EURO connector on the customer side

Safety:

  • circumferential foot guard switchboard
  • tube breakage protection in the cylinder
  • lowering brake valve
  • maintenance supports
  • pressure relief valve
  • the design complies with the applicable EN1570-1 guidelines

Surface: APPLICATION IN THE INTERIOR:

  • steel structure blasted with pretreatment according to EN ISO 12944 in combination with ST 3 pretreated parts according to DIN ISO 8501/1.
  • coating material 2 K-PUR thick film with high chemical and oil resistance.
  • colour RAL 7024 graphite grey

Particularities:

  • Lifting table according to customer specifications in Ex-protection II 3G ExIIB T3 Zone 22.
  • 2 Strokes / hour in 2-shift operation
  • Ex-bellows around under the platform
  • Pit installation
  • Ring screws for lifting the LT (lifting table) from the pit
  • Revision flap in the platform
  • Set-up bolts with rubber buffer as end position damping
  • Heavy duty dowel included
  • INCLUDING tilt platform with plug-in stop, 500 mm high, on one longitudinal side
  • (Tipping or lowering up to a maximum of 45° over the longitudinal side is only possible if the lifting table has been moved so far up that the crushing edge no longer poses a risk of crushing)

Without assembly without removal

Contact

Do you have questions about the product? Do not hesitate to contact us!